WinLink 1000 Installation and Operation Manual Index
—R—
Radio link status, 4-6
Radio signal strength, 4-6
Rate, selecting, 3-9, 2-16
ratio
different clocks, D-3
Requirements, 2-2, 2-7
Reset, 4-7
Restoring configuration, 4-8
re-triggers, D-2
—S—
Saving the configuration, 4-7
Selecting the channel, 3-4, 2-12
Service parameters, 3-10
Setup, 2-1, 2-3
of software, 2-7
Site Requirements, 2-2
Slave mode, D-2
slips
pattern, D-2, D-3
Software, 2-7
SSID, 2-12
Statistics, 4-6, 5-2
Subnet mask, 3-16
Support, 5-11
System, 2-1
—T—
Technical support, 5-11
Temperature, operating, 2-2
timing, D-2
examples, D-3
Toolbar, 4-5
TPC, 3-6, 3-7, 2-14
Traffic rate, 4-6
transmit clock, D-1, D-2
Transmit Power, 3-15
Trap destination, 3-16
Troubleshooting, 5-1, 5-7
trunk number, D-2
Trunk Port, A-2
Turning off, 4-4
Turning on, 4-3
Typical installation, 2-4
—U—
User equipment
connecting, 3
User port
connectors, A-2
—W—
WinLink 1000 System, 2-1
WinLink 1000 units
installing, 1
normal indications, 4
operating, 4
troubleshooting, 5
I-3
To Previous Page
Loading...
