Pump Cycle(s) (Advanced Mode)
This sets the length of time for one cycle of the pump running.
1. Press [+] repeatedly to select a desired number. Numbers
increase from 0 to 9. Once 9 is reached, pressing [+] again
“wraps” around back to 0.
2. Press [-] to advance to the next digit.
Repeat this process until all digits of the new value are
entered.
3. Press [MODE] to register the Pump Cycle(s) value.
4. Press [+] to save the value, [MODE] to go back and edit the
value, or [-] to cancel and return to the menu.
Note: If you set an invalid input value, then it says “Invalid input!”
and this set of buttons is shown along the bottom of the display:
•
Press [MODE] to go back and input a valid value.
•
Press [-] to exit back to the main menu without making a
change.
Pump Status (Advanced Mode)
This tells you whether the pump should be on or off, and allows you
to set whether the pump is on or off.
•
Press [-] to select On or Off (the black dot in the circle
indicates the selection).
•
Press [+] to make the change to your selection.
•
Press [MODE] if you want to exit without making a change.
To Next Page
Loading...
