Raisecom ISCOM6820-GP Installation Guide

Raisecom
ISCOM6820-GP (A) Installation Guide
3 Installing chassis
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
17

The size of the cabinet is fit for the ISCOM6820-GP device; there must be some room
around the ISCOM6820-GP device for heat dissipation.

The cabinet is able to provide enough power for the ISCOM6820-GP device.

The cabinet can be grounded properly.
Install the ISCOM6820-GP device in a cabinet as below.
Step 1 Fix the chassis to the cabinet with brackets. Sometimes, the cage nuts are already installed in
the position of the brackets when the device leaves the factory. However, you need to install
cage nuts if there is no cage nut installed, as shown in Figure 3-2.
Figure 3-2 Installing cage nuts
Step 2 Install standard cabinet brackets on the chassis, as shown in Figure 3-3 and Figure 3-4.
Figure 3-3 Installing standard brackets on the right side of the chassis

Raisecom ISCOM6820-GP Specifications

General

Brand	Raisecom
Model	ISCOM6820-GP
Category	Network Hardware
Language	English