Error Codes R&S SM300
Version 04 102
Service Manual SM300: 1147.1652.00 Instrument Part No SM300: 1147.1498.03
5.2.3.2 Power Supply Module
EventId Description Parameters Parameter Description
0×6150 Event_Monitor See Table 5-7: Additional information about
event monitor (event 0×6050) parameters
0×6130 PASSWORD int16 0×80 – Good_Pwd
0×81– Bad_Pwd
0×6140 BOOT_EVENT Transmission of errors at boot time (errors
defined in ose_user_errors.h)
0×6160 SHUTDOWN uint16 SHUTDOWN Indicates to host that the system is going
down (SHUTDOWN=1)
0×6170 SERIAL_
TRANSFER_
HANDSHAKE
uint16 SERIAL_
TRANSFER_HANDSHAKE
Indicates that a serial transfer was cancelled.
(ACK=0×33 (acknowledge),
NAK=0×CC (not Acknowledge),
RST=0×66 (reset)
Handshake signals sent from the STPC and
transferred via the PS:
FS_TOO_BIG=0×C0 (file size too large)
FS_DEST_ERR=0×C1 (destination error)
FS_PACK_ORD=0×C2 (packet order error)
FS_HEAD_ERR=0×C3 (header error)
(FS_EX_RDY=0×C4 (execution ready)
FS_TIME_OUT=0×C5 (receiver timeout)
FS_PS_NOT_RDY=0×C6 (power supply not
ready to send serial data)
FS_FILE_EXIST=0×C7 (file exists)
0×6180 HW_ERROR_
EVENT
0×6190 USB_CHANGE_
EVENT
Enum eUSB_Master Values are:
PC_Master = 0
Display_Master = 1
Interface_Master = 2
No_Master = 3
0×6110 USB_CHANGE_
AUTO
0×ffff If this event occurs, the system was in the
USB auto mode and the external PC was
plugged-in.
0×6120 OVER_
TEMPERATURE_
PS
– Overtemperature of the power supply
0×6121 OVER_
TEMPERATURE_
MODULE
– Overtemperature of a module
0×6191 BATTERY_
NOT_SUPPORTED
– The command to read the battery was
rejected because no battery is installed.
Table 5-6: Power Supply Module
To Next Page
Loading...
