R&S SM300 - Installation of Software Updates

R&S SM300 Installation of Software Updates and Drivers
Version 04 27
Service Manual SM300: 1147.1652.00 Instrument Part No SM300: 1147.1498.03
This is followed by the installation of the device driver for the Rohde &
Schwarz Power Supply. Windows generally "remembers" all the
necessary information when installing the Signal Generator R&S SM300
and installs the Rohde & Schwarz Power Supply without a query.
However, depending on the system, the installation assistant might be
activated.
In this case, repeat instructions 3. to 5. to successfully complete the
installation.
The drivers are now correctly installed and this can be checked using
the device manager.
1.2.2 Installation of Software Updates
Software application
The software of the R&S SM300 modules (control PC, SM300 generator
module, power supply) is updated using the “Series300 Software Manager“
application. The following section provides an introduction on how to do
this.

Note
Please install the “Series 300 Software Manager“ application. It is supplied
also on the GLORIS board.
The “Series 300 Software Manager” checks which modules require update
and performs the update for all modules in one step. It is not possible for
the user to update individual modules only.
Example filename for update: SM300_Release_1_1.out.