R&S SM300 - Detailed Description of Replacement Procedure; Protectors, Front and Rear

Instrument Assembly for Board and Module Exchange R&S SM300
Version 04 36
Service Manual SM300: 1147.1652.00 Instrument Part No SM300: 1147.1498.03
1.3.3 Detailed Description of Replacement Procedure
1.3.3.1 Protectors, Front and Rear
Removing
 Undo 4 side screws and 2 screws at top and bottom.
 Remove screws using tweezers if necessary (see
Figure 1-1).
 Take off protector (see
Figure 1-2).
Figure 1-1 Figure 1-2
Installing
 Remount protector on instrument. The side tabs on the protector must
be pressed into the slot.
Caution
The protector’s soft plastic can become damaged during installation!
 Fasten 4 side screws (DIN7985 M3×12).
 Fasten 2 screws at top and bottom (DIN7985 M3×6 for front;
DIN7985 M3×8 for rear).