R&S SM300 - Installing Steps for Windows XP

R&S SM300 Installation of Software Updates and Drivers
Version 04 25
Service Manual SM300: 1147.1652.00 Instrument Part No SM300: 1147.1498.03
1.2.1.2 Installing Steps for Windows
 XP
Connecting R&S
SM300 to the PC
R&S SM300 is connected to the PC via the USB interface. The connection
cable has two plug types. Plug A is connected to the computer (Ê computer
manual) and plug B is connected to the R&S SM300 (Ê R&S SM300
operating manual, Chapter 2.2 Rear View).
The CD ROM must be in the installation drive of the PC in order to install the
drivers.
1. Switch on the R&S SM300 and the PC.
2. Connect the instrument to the PC with the USB cable. The PC
(Windows) recognizes the instrument when it is connected and reports
new hardware. This message appears only when an R&S SM300 is
installed for the first time.
If the R&S SM300 is not automatically recognized, check that the USB
master switch of the R&S SM300 is at AUTO (Ê R&S SM300 operating
manual, Chapter 6.3.4.3 Configuring the Instrument Interfaces).
Installing device
drivers
3. Select <Install the software automatically> and click <Next> to
continue the installation.