R&S SM300 - Page 21

R&S SM300 Installation of Software Updates and Drivers
Version 04 21
Service Manual SM300: 1147.1652.00 Instrument Part No SM300: 1147.1498.03
The CD ROM must be in the installation drive of the PC in order to install the
drivers.
1. Switch on the R&S SM300 and the PC.
2. Connect the instrument to the PC with the USB cable. The PC
(Windows) recognizes the connected instrument and reports new
hardware. This message appears only when an R&S SM300 is installed
for the first time.
If the R&S SM300 is not automatically recognized, check that the USB
master switch of the R&S SM300 is at AUTO (Ê R&S SM300 operating
manual, Chapter 6.3.4.3 Configuring the Instrument Interfaces).