R&S ZNLE Series - Page 718

Command reference
R&S
®
ZNL/ZNLE
718User Manual 1178.5966.02 ─ 20
CALCulate:RIPPle...
The CALCulate:RIPPle... commands define the ripple limits and control the ripple
limit check.
CALCulate<Chn>:RIPPle:CLEar......................................................................................718
CALCulate<Chn>:RIPPle:CONTrol:DOMain......................................................................718
CALCulate<Chn>:RIPPle:DATA.......................................................................................719
CALCulate<Chn>:RIPPle:DELete:ALL..............................................................................720
CALCulate:RIPPle:DISPlay:RESult:ALL[:STATe]............................................................... 720
CALCulate<Chn>:RIPPle:DISPlay[:STATe]....................................................................... 721
CALCulate<Chn>:RIPPle:FAIL?.......................................................................................721
CALCulate:RIPPle:FAIL:ALL?..........................................................................................721
CALCulate<Chn>:RIPPle:RDOMain:FORMat....................................................................722
CALCulate<Chn>:RIPPle:SEGMent:COUNt?....................................................................722
CALCulate<Chn>:RIPPle:SEGMent<Seg>:LIMit............................................................... 723
CALCulate<Chn>:RIPPle:SEGMent<Seg>:RESult?...........................................................723
CALCulate<Chn>:RIPPle:SEGMent<Seg>[:STATe]........................................................... 724
CALCulate<Chn>:RIPPle:SEGMent<Seg>:STIMulus:STARt...............................................724
CALCulate<Chn>:RIPPle:SEGMent<Seg>:STIMulus:STOP............................................... 724
CALCulate<Chn>:RIPPle:SOUNd[:STATe]........................................................................725
CALCulate<Chn>:RIPPle:STATe......................................................................................725
CALCulate<Chn>:RIPPle:STATe:AREA............................................................................ 726
CALCulate<Chn>:RIPPle:CLEar
Resets the limit check results for the ripple test.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Usage: Event
Manual operation: See "Clear Test" on page 442
CALCulate<Chn>:RIPPle:CONTrol:DOMain <SweepType>
Deletes the existing ripple limit ranges and (re-)defines the physical units of the stimu-
lus values of the ripple limit lines. The unit of the ripple limit is defined via
CALCulate<Chn>:RIPPle:RDOMain:FORMat.
Suffix:
<Chn>
.
Channel number used to identify the active trace
VNA command reference