R&S ZNLE Series - Page 964

Command reference
R&S
®
ZNL/ZNLE
964User Manual 1178.5966.02 ─ 20
Suffix:
<Ch>
.
Channel number
<Seg> Sweep segment number
Parameters:
<SegSweepTime> Segment time. The minimum segment time depends on the
other channel settings, in particular on the number of points
([SENSe<Ch>:]SEGMent<Seg>:SWEep:POINts), the IF
bandwidth ([SENSe<Ch>:]SEGMent<Seg>:BWIDth[:
RESolution]) and the delay for each partial measurement
([SENSe<Ch>:]SEGMent<Seg>:SWEep:DWELl). The maxi-
mum is 1000 s. Changing the duration leaves the number of
points unchanged but directly affects the delay.
Range: Minimum value to 1000 s
*RST: Minimum value, depending on the channel settings.
This default value corresponds to automatic sweep
time setting in manual control.
Default unit: s
Example:
SEGM:ADD
Create a new sweep segment no. 1 in channel no. 1.
SEGM:SWE:TIME 0.1
Increase the segment sweep time to 0.1 s.
SEGM:SWE:TIME:SUM?
Query the total duration of the segmented sweep. The response
is 0.1, because there is only one sweep segment.
Manual operation: See "Optional Columns" on page 337
[SENSe<Ch>:]SEGMent<Seg>:SWEep:TIME:CONTrol <Boolean>
Selects common or independent "Segment Sweep Time" settings for the sweep seg-
ments.
Suffix:
<Ch>
.
Channel number
<Seg> Sweep segment number. This suffix is ignored; the command
controls the whole segmented sweep.
VNA command reference