Adjusting the installation heigh
Pict. 1
If the altitude of installation is higher than the unit
default value (0-299m) it is necessary to modify and
validate.
• Modify the altitude (300 m steps)
• Do not forget to validate
Calibration
The VarioCooking Center
®
are factory calibrated.
There is no need to calibrate it again after installa-
tion altitude adjustment.
Stainless steel cleaning cloth
We attach great importance to the quality of the
installation. Also we deliver in the starter kit a set
of cleaning wipes soaked with highly refined mineral
oil. Do not use it inside the pan.
Pict. 2
First startup
VCC
Installation Altitude
Please check and configure
Installation altitude
- 23 -
To Next Page
Loading...
Need help?
General
