4. In System Preferences, click Displays and select the RAVEN MTi as your main
display.
IMPORTANT:
As in many studios, your computer may be located in a room far away from your
console. For HDMI cable lengths over 15ft, a HDMI signal booster is required. This
will ensure the video signal reaches the display with no signal degradation.
You will now need to install Multi-Touch Drivers in order to get touch response
from RAVEN MTi2, using the RAVEN MTi2 Installer Package.
MTi Software Installation and Touch Calibration
Installing the RAVEN MTi software and calibrating the touchscreen is a quick process.
IMPORTANT
Calibration is the most important process for accurate use of the screen. Failure
to calibrate properly will result in poor touch performance.
DO NOT RUN ANY APPLICATIONS UNTIL CALIBRATION IS COMPLETED.
1. Run the RAVEN MTi installer and download the drivers onto your hard drive.
NOTE: Make sure to use the included UNINSTALL MULTI-TOUCH PLATFORM
application, available in your Slate User Account if any pre-existing Multi-Touch
software has been installed, as existing Multi Touch software will complicate
the install process. In this case, the uninstallation package should be run
primary to the included Multi-Touch Platform Driver package.
2. Restart your computer for changes to take effect.
To calibrate RAVEN MTi use the following procedure:
To Next Page
Loading...
Need help?
General
