Raven RGL 600 - Notations Used for Display Figures and Menu Navigation Diagrams

7
Notations used for display figures and menu navigation diagrams
The following notations are used to describe the Smartbar LED indicators and alphanumeric
displays:
This example shows a multiple sequence alphanumeric display. In this example, 1.55 acres
is displayed by alternating the right alphanumeric display between ‘ 1’ and ‘.55’. The Smart-
bar display alternates between [a] and [b]. In some
Configuration Mode displays, up to 5
sequences are used to display large numeric values.
The following notations are used for menu navigation diagrams:
SWA
SWT
SWA
SWT
main-menu item (Left alphanumeric display shows SWA)
sub-menu item (Left alphanumeric display shows SWT)
At the Swath (SWA) main-menu,
press the DOWN button to move to
the Swath Type (SWT) sub-menu.
Execute an action.
For this example, Set the Tape Reference Point.
Set Tape
Refernce point
MENU Button pressed and released
DOWN Button pressed
SELECT Button pressed
press and hold the MENU Button for 3 seconds
Automatic (no button press)
[
a]
[
b]
- LED is OFF
- LED is ON
- LED is flashing ON/OFF
- LED is flashing OFF/ON
(used to denotate alternating flash when shown with
)