14
The Smartbar Configuration Mode
There are normally 7 main menus in the Configuration Mode as listed here:
GPS GPS Receiver Status monitoring
SWA Swath Configuration parameters
SYS System Configuration (includes BAUD rate)
MSG Output Messages control (present only if SYS-MSG=ON)
DSP Display Settings (present only if SYS-DSP=CFG)
IAS Inertial Augmentation System (configuration for optional tilt compensation)
DIA Diagnostic Built-In Testing
Pressing the MENU button at a Configuration Mode main menu will view the next Configura-
tion Mode main menu. Pressing the MENU button at last main menu will view the first main
menu [GPS]. The SELECT button is not funtional for Configuration Mode main menus. Press
the DOWN button to go down from a main menu, into its sub-menus. Then press the MENU
button to go through the sub-menus. After the MENU button has been pressed for all of the
sub-menus, the same main menu is displayed again. This provides a quick return to a sub-
menu that may have been passed unintentionally. The DOWN button will reenter the same
main menu’s sub-menus, or the MENU button will proceed to the next main menu.
The Output Messages control (MSG) main menu is present only if SYS-MSG is set on ON.
The Display Settings (DSP) main menu is present only if SYS-DSP is set to configure (CFG).
The Inertial Augmentation System (IAS) main menu is present only if optional tilt compensa-
tion is installed.
To Next Page
Loading...