25
THE SMARTBAR CONFIGURATION MODE (continued)
DSP - Display Settings (continued)
CON Contour Control
Contour Control configuration is present only if Swath Type (SWT) is set to CON.
Press SELECT button to set DSP-CON to 2BT, 1BT, or 0BT (Two Button, One Button,
or No Buttons). The Contour Control setting determines how much operator activity is
required when turning between rows using Contour Swathing. See the section “Con-
tour Swathing - Contour Control Configuration Setting” for more details.
SWW Swath Width Control
Press SELECT button to set Display Settings SWW (Swath Width) to OPR (Opera-
tional mode) or CFC (Configuration Menu). The default setting is OPR (Operational
mode). When OPR is selected, the SWW (Swath Width) menu will appear in the
Operational mode and in the Configuration Menu under SWA (Swath).
When CFG is selected, the SWW (Swath Width) menu will appear only in the Config-
uration Menu under SWA (Swath).
LSC Limit Swath Cal
Press SELECT button to set Settings LSC (Limit Swath Calibration) to ON or OFF.
The default setting is ON.
When LSC-ON is selected the Swath Calibration is limited to 1/4 of the current swath
width setting.
When LSC-OFF is selected the Swath Calibration limit is bypassed.
See the section “Swath Calibration” for more details.
IAS - Inertial Augmentation System
This IAS configuration main menu will be present if your Smartbar has the optional Tilt Sensor
upgrade installed. The four sub-menus under IAS are TLT (Tilt Mode), AHT (Antenna Height),
and ANG (Angle Display and Calibration). See the section “Smartbar Tilt Upgrade Option -
IAS Configuration” for configuration details.
DIA - Diagnostic Built-In Testing
DSP RGL 600 Built-In Display Test
Press the SELECT button to execute the Display Test sequence. The SELECT button
is pressed two times in the sequence to proceed past display inspection points. The
MENU button may be pressed at any time to abort the Display Test.
Shown with Boom Switch #1, #2, #3, and #5 closed
To Next Page
Loading...