24
THE SMARTBAR CONFIGURATION MODE (continued)
DSP - Display Settings (continued)
SAV Save Position Distance
Press SELECT button to set DSP-OFF to XTO or RNG (Cross Track Distance or Range).
When swathing a field, the current position can be saved by pressing the SELECT
button at a menu “SAV POS”. the DSP-SAV configuration controls what the right hand
alphanumeric display is showing while leaving and returning to a Saved Position.
The default setting is XTO (Cross Track Distance). When DSP-SAV is set to XTO, off-
set error to the saved swath line is displayed similar to swath offset error when there is
no Saved Position.
When DSP-SAV is set to RNG (Range), the right hand display shows the distance
from the current position to the Save Position. See the section “Saving Your Present
Position” for more details.
APR Headlands Approach Display
Press SELECT button to set DSP-APR to ON, OFF, or FLA (Flash).
When swathing with headlands, there are two approaches to headland boundaries.
One is from within the field. You approach the boundary entering the headland area.
This approach requires the spray control to be turned OFF by the operator at the head-
land boundary. The other is from the headland area into the field. This happens after
making an end of row turn and requires the spray control to be turned ON by the
operator at the headland boundary.
The Headland Approach Display indicates distance to the headland boundary as the
machine is approaching it. This is an aid to help the operator control the spray at the
proper point. The Headland Approach Display is shown to the operator in place of
the swath number. (i.e. in the Smartbar left alphanumeric display).
The default DSP-APR setting is ON. The DSP-APR setting allows the Approach Dis-
play to be turned OFF, or to flash (FLA). When DSP-APR is set to FLA, the swath
number and the approach distance are shown alternately in the left alphanumeric
display. See the section “Swathing with Headlands - Headland Approach Display”
for more details.
SPL Special Angle and Offset error display
Press SELECT button to set DSP-SPL to ON or OFF.
The Special Angle and Offset error display is used to indicate distance away from the
swath target when the machine is nearly perpendicular to the swath line. In this orien-
tation, it is difficult to determine which way the machine is heading. Therefore the left
or right sense of error offset indications may be unclear. See the section “Special
Offset and Angle Displays” for more details. DSP-SPL provides a configuration to
turn OFF this Special Angle and Offset error display.
To Next Page
Loading...