Raven RGL 600 - SWA - Swath Configuration Parameters; SWT Swath Type; PMR Pivot Minimum Radius; CON Contour Type

18
THE SMARTBAR CONFIGURATION MODE (continued)
SWA - Swath Configuration parameters
SWT Swath Type
Press SELECT button to select Swath Type Back-and-Forth (BF), Snap-To-
Swath (SNP), Row Swathing (ROW), Pivot swath pattern (PVT), Contour
Swathing (CON), Seed Swathing (SED) Squeeze pattern (SQ), Racetrack
pattern (RT), or One Button (ONE).
Swath
Type
Description
Function
BF
Back-and-Forth
SELECT button
is used
(in the Operational Mode)
to
advance or decrease the swath number as required.
SNP
Snap-To-Swath
The swath number is set automatically to the swath
nearest the curent position.
ROW
Row Swathing
Special guidance is shown for driving down crop rows.
PVT
Pivot pattern
Sequences to mark and follow a circular pattern are
used.
CON
Contour Swathing
Guidance to curved swath patterns is given.
SED
Seed Swathing
Used for seeding much like BF except that whenever
the
SELECT button
is pressed to advance to the next
swath, an "auto swath calibrate" occurs.
SQ
Squeeze pattern
A special swath number sequence is used for aviation
crop applications.
RT
Racetrack pattern
A special swath number sequence is used for aviation
crop applications.
ONE
One button swathing
One button setting is the same as Snap-To-Swath
operation, with no need to set point A and B.
PMR Pivot Minimum Radius
This configuration setting will only be present if SWT=PVT (Pivot Swathing). The PMR
setting controls the smallest circle to be sprayed.
Press SELECT button to set the Pivot Minimum Radius as required. As you press the
SELECT button the PMR increases by 10 ft (FT/FTF) or 1.0 meter (MT). The DOWN
button decreases the PMR by 1 ft (FT/FTF) or 0.1 meter (MT). You can hold down
each button to quickly change the settings.
The maximum PMR setting is 999 feet or 99.9 meters.
CON Contour Type
This configuration setting will only be present is SWT=CON (Contour Swathing).
Press SELECT button to select between Contour Types CRS (Course), NRM
(Normal), FIN (Fine), or VFN (Very Fine). The default setting is NRM and may be
used in most applications. The FIN and VFN settings reduce the maximum length
of a contour swath. The CRS setting increases the maximum length of a contour
swath.
See the section Contour Swathing - Contour Type Configuration Setting for
details on setting the Contour Type.