31
Outside
described areas
Save Lights
FLASH TOGETHER
Zones used
to describe
Leaving and Returning
to a
Saved Position
Leave Zone
60ft square
centered on Saved Position point.
Save Lights
FLASH ALTERNATELY
when leaving.
normal
return
path
normal
return
path
Arrive Zone
30ft wide x 20ft long,
begins 5 ft before
Saved Position point.
Save Lights
ON STEADY
after reaching this zone.
Saved Position
Point
COG
Approach Zone
±10ft from swath line
of Saved Position.
Save Lights
GO OUT
when returning.
COG line
Using the Smartbar ‘SAV POS’ function, you can leave your current swathing position and return to it
later to continue the present swathing operation. To save your current position, locate the ‘SAV POS’
screen on the menu and press the SELECT button. A position may be saved after stopping. How-
ever, do not back up prior to saving a position or the saved COG will be in the wrong direction.
In the following description, the upper and lower center green LED’s are referred to as the ‘save
lights’.
After saving your current position:
The Save Lights will FLASH ALTERNATELY until you exit the Leave Zone.
The Save Lights will FLASH TOGETHER after you have left the Leave Zone.
The Save Lights will GO OUT when you enter the Approach Zone indicating a
correct approach direction. (i.e. You are going in the same direction.)
The Save Lights will come ON STEADY when you reach the Arrive Zone. The
Smartbar is then ready to continue swathing.
When returning to a Saved Position Point, use normal swath guidance to find the Saved Position
swath. For BF and SNP the swath number is locked so all swath guidance indicators will guide you
back to the correct swath line. Look at the swath offset LED’s and the angle LED’s to find the Saved
Position swath. If you are perpendicular to the swath line, use the Special Offset and Angle Displays
(see separate section) to find your way back. Otherwise, notice if the offset distance (right alphanu-
meric) is increasing or decreasing to locate the Saved Position swath. Also the General Direction to
Target Indicator (see separate section) will point back to the saved position when there are available
digits on the offset display. Once the Saved Position Swath is located, use the diagram above to
navigate to the Saved Position point.
SAVING YOUR PRESENT POSITION
To Next Page
Loading...