54
AHT - Antenna Height
The GPS antenna height is entered and displayed. This is an important part of the tilt
error correction. It must match the measurement between the antenna mounted on
the applicator machine to the ground.
The setting range is 1.0 feet to 40.0 feet or 0.10m to 9.99m.
Press the SELECT button to increase the Antenna Height by 1.0 feet or by 0.10 meter.
Press the DOWN button to decrease the Antenna Height by 0.1 feet or by 0.01 meter.
ANG - Tilt Angle Readout and Calibration
The measure tilt angle is displayed as -179 degrees (tilted to the left) to 180 degrees
(tilted to the right). 0 degrees is displayed when level. The tilt sensors must be cali-
brated after installation any time the Smartbar firmware is updated.
To calibrate the tilt sensors:
1. Stop the applicator machine on known level ground.
2. Press the SELECT button to calibrate the tilt sensors.
3. ANG display will read approximately 0 degrees.
Note:
The ANG display will indicate inclination for all angles. However, tilt correction
calculations are limited to
+20
o
.
To Next Page
Loading...