68
APPENDIX B - RAVEN INVICTA DGPS RECEIVER SETUP
Refer to the Invicta front panel shown below and use the following steps to setup you Invicta
DGPS Receiver to operate with the RGL 600 Smartbar. Refer to the operation manual
supplied with your Invicta DGPS Receiver to clarify or modify these steps.
From the HOME screen, press the LEFT ARROW (‘enter’) key once to arrive at
th OUTPUT CONFIG menu screen.
Press the DOWN ARROW key until you reach the Baud Rate Setting menu
screen for your chosen interface port (A or B). If the port’s baud rate is not
already displayed as “19200 bps”, press the LEFT ARROW (‘enter’) key to
hightlight the field.
Using the UP and DOWN ARROW keys, set the baud rate to 19200 bps and
then press the LEFT ARROW (‘enter’) key again to make your selection final.
To configure the NMEA message output for use with the RGL600 lightbar, press
the DOWN ARROW once to move from the Baud Rate menu screen to the
MSGOUTPUT menu screen for the chosen port (A or B).
Press the RIGHT ARROW key once to enter the message-type selection screen.
Press the UP or DOWN ARROW key until “GGA” is displayed at the message
type.
Press the LEFT ARROW (‘enter’) key to hightlight the output interval.
Use the UP and DOWN ARROWS to select the proper output rate (0.1 see if
your receiver has the 10 Hz option installed, else 1.0 sec) and press the LEFT
ARROW (‘enter’) key to finalize your selection.
Next, press the UP or DOWN ARROW key until “VTG” is displayed as the
message type.
Follow the same steps shown above to set the message output interval to the
VTG message.
Press the UP and DOWN ARROWS simultaneously to return to the HOME
menu screen and you’re ready to swath!
To Next Page
Loading...