Raven RGL 600 - SCL Guidance Offset Scale Sensitivity; ANG Angle Indicators

20
THE SMARTBAR CONFIGURATION MODE (continued)
SCL Guidance Offset Scale sensitivity
Press SELECT button to select between Swath Scales Fine (FIN), Normal (NRM),
Coarse (CRS), or Automatic (AUT). There are 8 offset LED’s on each side of center.
LED swath offset error distances for English units in feet (FT or FTF) as follows:
LED swath offset error distances for Metric units in meters (MT) as follows:
LED swath offset error distances for Auto SCL in percentage of Swath Width as
follows:
Custom Guidance Scales can be installed via the Raven Configuration Block (SCB).
Custome Scale names can also be assigned by the SCB. If custom scale names are
present in the SCB, those names will replace FIN, NRM, CRS, or AUT as Guidance
Offset Scale identifiers.
When the SCB control “Enable Scales Display” is turned ON, the DOWN button is
used to display the Offset distance for each LED of the Offset Guidance display. Press
the DOWN button to sequence through 8 Offset settings. Corresponding Offset LED’s
illuminate indicating which Offset value is displayed. When “Enable Scales Display” is
ON, only the SELECT button may be used for selecting Swath Scales. This is be-
cause the DOWN button is used to display the Scale settings.
ANG Angle Indicators
Press SELECT button to turn Angle Indicator LEDs OFF, ON, or FIN. The angle LED’s
indicate the difference between your Course Over Ground (COG) and the swath line
you are following.
LED swath angle error degrees for ON and FINe as follows:
NOTE: A special angle display indicates that COG is not valid and therefore the angle
error can not be displayed. This indication is all angle LED’s off except the far
left angle LED and the far right angle LED. This condition is usually caused by
low Speed Over Ground (SOG).
# of LED's
1
2
3
4
5
6
7
8
Fine 0.31.01.52.02.53.03.55.0
Normal 1.0 2.0 4.0 6.0 8.0 10.0 12.0 14.0
Coarse 4.0 6.0 12.0 18.0 24.0 30.0 36.0 42.0
# of LED's
1
2
3
4
5
6
7
8
Fine 0.1 0.2 0.4 0.6 0.8 1.0 1.2 1.4
Normal 0.3 0.6 1.2 1.8 2.4 3.0 3.6 4.2
Coarse 1.2 1.8 3.6 5.4 7.2 9.0 10.8 12.6
# of LED's
1
2
3
4
5
6
7
8
Auto 0.5% 1% 2% 4% 10% 20% 40% 50%
# of LED's
1
2
3
4
5
ON 1 3 6 10 15
FIN 0.5 1.5 3 6 10