Raven RGL 600 - Entering and Leaving the Configuration Mode

13
Entering and Leaving the Configuration Mode
Controlled access to the Configuration Mode prevents inadvertent entrance during normal
Operational Mode activity. Once the Configuration Mode is entered, there are several main
menus that are displayed sequentially by pressing the MENU button. Configuration Mode
main menus are identified by the word “CON...FIG...URE...” displayed sequentially in the right
alphanumeric display (see the [GPS] main menu example below). The Configuration Mode
can only be entered from the Operational Mode main screen [RGL 600]. To enter the Configu-
ration Mode, press and hold the MENU button for approximately 3 seconds. When the
[TO...CFG] screen shows (see below), the MENU button may be released. Press the
SELECT button to enter the
Configuration Mode or press the MENU button to return to the
[RGL 600] main screen.
The Configuration Mode GPS main menu is displayed first as shown here.
Return to the Operational Mode from any Configuration Mode menu by pressing and holding
the MENU button for approximately 3 seconds. When the [TO...OPR] screen shows (see
below), the MENU button may be released. Press the SELECT button to return to the
Operational Mode or press the MENU button to stay in the Configuration Mode.
Press and hold
MENU to enter
Configuration
Mode
SELECT
enters
Configuration Mod
e
Press MENU to cancel
Configuration Mode
[
c]
[
d]
[a
]
[
b]
Display
sequences
between
[a], [b], [c], and
[d]
Typical of all
Configuration Mode
Main Menus
Press and hold
MENU to return to
Operational Mode
SELECT
returns to
Operational Mod
e
Press MENU to cancel
Operational Mode