Raven RGL 600 - SWW Swath Width; DIR Swath Direction

19
THE SMARTBAR CONFIGURATION MODE (continued)
SWW Swath Width
Press SELECT button to set the Swath Width as required. The boom width of your
machine determines the swath width. As you press the SELECT button the width
increases by 5 ft (FT), 5.0 ft (FTF), or 10 decimeters (MT). The DOWN button
decreases the width by 1 ft (FT), 0.1 ft (FTF), or 1 decimeter (MT). You can hold down
each button to quickly change the settings.
The following table shows SWW setting ranges for each units setting (SYS UTS):
units min SWW max SWW
FT
- feet
5
ft
500
ft
FTF
- feet fine
5.0
ft
95.0
ft
MT
- metric
1
dm (0.1m)
999
dm (99.9m)
DIR Swath Direction
This configuration setting is not present if the Swath Type (SWT) is set to ROW, PVT,
CON, SQ, or RT.
Press SELECT button to select AUT (Automatic) or MAN (Manual) Swath Direction
control. The default is AUT and should be used in most applications to eliminate a
button press after marking the A-B line.
The Swath Direction determines on which side of the A-B line swath numbers are
positive. Generally, this is the direction you will work the field.
When DIR is set to AUT, the Swath Direction is set automatically as the machine turns
past 75 degrees from the Course Over Ground (COG) when the B point was marked.
After the B point is marked, the Smartbar displays ‘AUT DIR’ until the 75 degree turn is
completed. Then the Swath Direction is set and Swath #2 guidance is displayed. The
Swath Direction may be set prior to completing the 75 degree turn, by pressing the
SELECT button, if desired.
When DIR is set to MAN, the Swath Direction is set by pressing the SELECT button
after marking the B point and turning in the desired direction to work the field. After the
B point is marked, the Smartbar displays ‘SET DIR’ until the SELECT button is pressed
to set the direction. Then Swath #2 guidance is displayed.