4
SMARTBAR DISPLAY
A - Left alphanumeric display showing swath number 3 bright red digits/characters
B,F - Left and right GPS Status, see table under “Alarms” 3 vertical bright amber LED’s
(All LED’s out is good, any LED on is a problem)
C - Left Offset distance error, turn left to correct 8 horizontal bright red LED’s
D - Center Guidance Status 3 vertical bright green LED’s
The center green LED is on if no offset distance error LED’s are on. The top and bottom LED’s
are both on if a swath is established and the Smartbar is showing guidance (except for Head-
lands and Saving Your Present Position). When a swath has been established, the Smartbar
shows guidance on all but a few screens, such as the BAUD rate screen. In general, when the
top and bottom LED’s are on, it is okay to spray. The top and bottom LED’s are described in
‘Saving Your Present Position’ and ‘Headlands’.
E - Right Offset distance error, turn right to correct 8 horizontal bright red LED’s
G - Right alphanumeric display showing offset distance 3 bright red digits/characters
(The left digit shown displays a General Direction to
Target Indicator. The display shown is pointing to the
target swath line, which is to the left).
H - Left Angle error, turn left to correct 5 horizontal bright amber LED’s
I - Right Angle error, turn right to correct 5 horizontal bright amber LED’s
The Smartbar shows guidance on all screens that do not use the guidance LED’s for something else.
When FT (feet) or FTF (feet fine) units are selected, swath offset distance is in feet.
When MT (metric) units are selected, offset distance is in decimeters.
IMPORTANT:
For metric units, a value of 123 is read as 123 decimeters or 12.3 meters.
To Next Page
Loading...