46
Configuration Steps for Contour Swathing
To use Contour Swathing, enter the Configuration Mode and navigate to the Swath (SWA)
menu. Set the Swath Type (SWT) to CON. Set the Contour type (CON) to Normal (NRM),
Fine (FIN), Very Fine (VFN), or Course (CRS). Set the Swath Width (SWW) to the dimension
across each swath. The Swath Direction Control (DIR) is not used for Contour Swathing. Set
the Offset Guidance Scale (SCL) and Angle display (ANG) as for parallel swathing to control
guidance indication displays. The Headlands Type (HDL) is not used for the Contour Swath-
ing. Set Along Track antenna Offset (ATO) and Across Track Antenna Offset (XTO) as for
parallel swathing.
Contour Control (DSP-CON) is set to two-button (2BT) by default. To use one-button (1BT)
or no button (0BT) Contour Control, first navigate to the System (SYS) configuration main-
menu. Set SYS-DSP to Configure (CFG)). This will activate the Display Settings (DSP)
configuration main-menu. Go to the Contour Control (DSP-CON) sub-menu and select 2BT,
1BT, or 0BT.
To Next Page
Loading...