51
ONE BUTTON SWATHING (ONE)
One Step - Basic Operation
A new Swath Type is added, which is SWT-ONE.
One Step operation is basically the same as Snap-To-Swath operation, without the need to set
point A and B.
Main Screen
One Step
Swath
Navigation
Swath number is
Displayed
If offset errors ar
showing press
SELECT
to reset end Mark
SELECT
to Calibrate
Swath Line
Press DOWN to Swath Calibration
Press SELECT to Calibrate Swath
Reset End Mark / Turn towards Swath #2 and continue snap-to-swath.
Press SELECT to Set start - End Mark (Swath #1 in guidance mode).
Operational Steps:
1. While moving in the direction of the reference swath, press the SELECT button at the
“ONE SET” menu. This sets the Start mark to the current position and the End mark
ahead by four swath widths in the direction of the present COG (Course Over Ground).
Guidance and offset indicators are shown immediately with “ONE” showing in the left
alphanumeric display.
2. Continue driving the reference swath. If offset erros are showing, press the SELECT
button to reset the End mark.
3. At the end of the reference swath, turn toward the second swath and continue Snap-
To-Swath. The swath number now shows in the left alphanumeric display.
4. To calibrate the reference swath position, press the DOWN button. The promp “CAL
SWA” will be shown immediately. To calibrate the reference swath, press the SELECT
button. To abort, press the MENU or DOWN button.
press MENU Button
press DOWN Button
press SELECT Button
press and hold MENU Button
Automatic (no button press)
ONE
off
set
enter
Configuration
Mode
RGL 600
One Step - Basic Operational Mode
Menu Navigation Diagram
BRT
Power
ON
SET ASWW
Set
Brightness
Snap to Nearest swath #
off
set
swath
#
Complete
turn toward
Swath #2
Set
Swath Width
only if initial
Swath Navigation
has not been set
Set the A mark
Reset
End Mark
CAL SWA
Calibrate
Swath Line
To Next Page
Loading...