37
10. Position the machine for the desired beginnng of the DH3-4 line segment. This may be
a fence line or field boundary in many cases. Press the SELECT button to set the DH3
mark. This display will indicate “SET...DH4”. Press the DOWN button for straight-line
guidance as required. This is called a temp DH4.
11. At the end of the DH3-4 line, press the SELECT button and turn the applicator OFF.
This marks DH4. Turn toward the field and guidance is given for entering the field
along the DH3-4 inside headland area. Turn the applicator ON as required when
entering the field. Notice the top and bottom green LED’s will turn ON when the
machine passes the DH4 point.
12. Drive along the DH3-4 inside headland path. When the machine is aligned with the
end of the DH3-4 line, the center top and bottom LED’s will go OFF. This completes
the A-B line and headlands marking.
13. Press the SELECT button to calculate the acreage, and begin swath guidance along
the first swath parallel to the A-B line.
14. Press the MENU button to see the swath guidance screen.
(swath offset error is shown on the right)
15. Proceed with swathing and turn the applicator OFF and ON when turning between
swaths.
To Next Page
Loading...