Raymarine autopilot control unit - Chapter 2: Basic Operation

Chapter 2: Basic Operation 3
2 Basic Operation
Chapter 2: Basic Operation
The sections in this chapter explain how to use the basic functions on
your ST7001+ autopilot control unit:
Note: If you are using the control unit with a non-150/400 autopilot
system, refer to the notes in the Appendix.
2.1
Using the control unit
Summarizes the key functions and screen layout on the
ST7001+ control unit.
page 4
2.2
Using Auto mode
Provides instructions for engaging/disengaging the
autopilot, using Auto mode and adjusting the
autopilot’s performance.
page 6
2.3
Adjusting display/keypad lighting and
contrast
Explains how to change the lighting and contrast on
the control unit display and keypad.
page 15