EasyManuals Logo

Raymarine autopilot control unit User Manual

Raymarine autopilot control unit
139 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
50 ST7001+ Autopilot Control Unit - Owners Handbook
5 Installing the ST7001+
5.3 SeaTalk connections
The SeaTalk connections on the ST7001+ provide it with its 12 V DC
power supply and allow it to share data with SeaTalk equipment.
Connecting to a course computer
If you are using the ST7001+ as the main control unit for a course
computer autopilot system, connect it directly to the course computer
SeaTalk terminals. To do this:
cut off the moulded plug at one end of the SeaTalk cable
strip 5 mm (
1
/
2
in) of insulation from each wire
then connect to the course computer terminals as shown
Note: If you are connecting the ST7001+ to a course computer
autopilot system that includes other control units, refer to the
information contained in the Autopilot System Installation Guide.
Connecting to SeaTalk
If you are using the ST7001+ as an additional control unit, use a
SeaTalk cable to connect it to another SeaTalk unit as shown.
Connecting to course computer as main control unit
ST7001+ or ST6001+
control unit (rear)
Type 150/400 course computer terminals
Screen
Red
Yellow
D5500-1
D5501-1
Connecting to SeaTalk as additional control unit
To SeaTalk
power supply
ST7001+ or ST6001+
control unit (rear)
SeaTalk
unit (rear)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Raymarine autopilot control unit and is the answer not in the manual?

Raymarine autopilot control unit Specifications

General IconGeneral
BrandRaymarine
Modelautopilot control unit
CategoryMarine Equipment
LanguageEnglish

Related product manuals