Chapter 6: Commissioning the Autopilot 55
6 Commissioning the Autopilot
Chapter 6: Commissioning the Autopilot
WARNING:
All new autopilot system installations MUST be calibrated.
If you have connected the ST7001+ to a newly installed Type
150/150G or Type 400/400G course computer autopilot system, you
must commission the system This involves a series of dockside
checks and then the seatrial calibration:
Note: If you have connected the ST7001+ to a non-150/400 autopilot
system refer to the notes in the Appendix.
6.1
Dockside Checks
With the boat safely tied up, you need check the
autopilot system and adjust some key autopilot
settings.
page 56
6.2
Seatrial Calibration
The purpose of this seatrial is to calibrate the compass
and optimize the autopilot set-up for your boat.
page 63
To Next Page
Loading...
Need help?
General
