Raymarine LightHouse Sport - Data Sources Menu

17
2.5 Data sources menu
When a network / system includes multiple sources of the same data
type, such as GPS / GNSS position data, the display will choose the
most appropriate source for the data. If you prefer, you can manually
select your own source for the data.
The Data sources menu can be accessed from the Settings menu:
Homescreen > Settings > This display > Data sources.
Each tab in the data sources menu enables you to view and select
your preferred data source for that type of data. The currently active
data source will display its current ‘value in use’. By default data
sources are selected automatically and the source for the data may
change depending on conditions.
With the
Manual selection toggle enabled, you can manually assign
your preferred source for the data. Manually selected data sources
will not change.
Manually assigning a data source
To manually assign a data source follow the steps below.
From the Homescreen:
1. Select
Settings.
2. Select the This display tab.
3. Select the
Data sources button.
4. Select the tab for the type of data you want to assign a source for.
Once a tab is selected the display will search the network and list
all compatible devices that provide that data type.
5. Use the
Up and Down buttons to highlight a device.
6. Press the
OK button to select the device as the source for that
data type.
The selected device will become the only source used for that data.