53
Switching fishfinder channel frequency
On Element™ HV variant displays DownVision™, SideVision™ and
RealVision™ 3D channels are available in both 350 kHz (Standard)
and 1.2 MHz (Hyper) frequencies.
With either DownVision™, SideVision™ or RealVision™ 3D channel
displayed:
1. Press the
Menu button.
2. Select the
Freq: option.
3. Select either
Standard (350 kHz) or HyperVision (1.2 MHz) as
required.
HyperVision™ channels provide higher resolution than standard
channels with reduced range.
Fishfinder channels — Element™ S displays
The following fishfinder channels are available on Element™ S variant
displays.
Sonar channel (Conical high CHIRP (200 kHz))
The sonar channel is available when connected to
any compatible transducer.
Fishfinder app controls
The Fishfinder app has 2 control modes, scrolling mode and pause /
playback mode. The behavior of some controls are dependent upon
control mode and also the fishfinder channel in use. The following
controls apply to DownVision™, SideVision™ and sonar channels. The
controls below do not apply to RealVision™ 3D channels.
Scrolling mode
Scrolling mode is the default mode when the Fishfinder app is opened.
In scrolling mode an image is displayed which scrolls from right to left
across the screen.
Control behavior:
• Pressing the
Plus button will switch to zoom mode.
• When in zoom mode pressing the
Plus or Minus buttons will
increase and decrease the zoom level.
• Pressing the
OK button displays the onscreen gain controls on the
left side of the screen.
• Pressing the
Waypoint button will place a waypoint at your vessels’s
current location.
• Pressing the Menu button will open the app menu.
To Next Page
Loading...
