Raymarine Lighthouse Sport 3.10 Series User Manual (English)

Questions and Answers:

M
Mr. Larry GibbsAug 17, 2025
How to fix a Raymarine Lighthouse Sport 3.10 Marine Equipment that does not turn on?
- M
  Mary WheelerAug 17, 2025
  If your Raymarine Marine Equipment product doesn't turn on or keeps turning off, there are several potential causes. First, check the relevant fuses and breakers and their connections, replacing them if necessary. Second, ensure the power cable connector is correctly oriented and fully inserted into the display connector and locked. Finally, verify that the power supply is wired correctly, following the installation instructions.
R
Randy MontgomeryAug 21, 2025
Why does my Raymarine Lighthouse Sport 3.10 Marine Equipment display 'No Fix' status?
- X
  xmelendezAug 21, 2025
  If your Raymarine Marine Equipment displays a 'No Fix' status icon or keeps losing its position fix, the issue may be due to your geographic location or prevailing conditions that prevent a satellite fix. Periodically check to see if a fix is obtained under better conditions or in another location. Also, ensure that the display has an unobstructed view of the sky, as being below decks or in close proximity to transmitting equipment like a VHF radio can cause this issue.
T
Teresa PerezAug 25, 2025
What to do if Raymarine Lighthouse Sport 3.10 cannot find router network?
- E
  Elizabeth MartinAug 25, 2025
  If your Raymarine Marine Equipment cannot find the router network, ensure the router is broadcasting and within range of your display. Also, verify that Wi-Fi is enabled on the display. If possible, power cycle the router and then turn the display’s Wi-Fi off and back on again. If possible, enable broadcasting in the router’s settings. Note that the display’s Wi-Fi can only connect to 2.4 GHz networks.
S
Samuel SmithAug 27, 2025
What causes Raymarine Marine Equipment to be in a restart loop?
- N
  Nicholas HarveyAug 28, 2025
  If your Raymarine Marine Equipment product will not start up and is stuck in a restart loop, it may be due to software corruption. You can try downloading and installing the latest software from the Raymarine website. As a last resort, on display products, attempt to perform a ‘Power on Reset’. Be aware that this will delete all settings, presets, and user data, reverting the unit back to factory defaults.
Z
zgutierrezAug 31, 2025
Why is scrolling image intermittent on Raymarine Lighthouse Sport 3.10?
- S
  Susan WolfeAug 31, 2025
  If your Raymarine Marine Equipment is not displaying a scrolling image or the image is intermittent, enable sonar ping from the shortcuts page by pressing the Power button. Check that the transducer has been installed in accordance with the instructions provided with the transducer. Inspect the transducer connector pins on the back of the display for any damage; if damage is detected, replace the display or send it to an authorized service agent for repair.
S
stephen30Sep 3, 2025
Why Raymarine Lighthouse Sport 3.10 cannot connect to network?
- M
  Monica HancockSep 3, 2025
  If your Raymarine Marine Equipment cannot connect to the network, ensure you are trying to connect to the correct Wi-Fi network, which can be found in the router’s settings. Also, make sure you are using the correct password, which is also in the router’s settings. Repositioning the display and, if possible, the router, so the structure is removed from the direct line of sight between the devices may help. If possible, change the Wi-Fi Channel that your router is using and retry the connection, as interference may be the root cause.
T
Trevor MartinSep 6, 2025
What to do if Raymarine Marine Equipment connection is slow?
- T
  Thomas GarzaSep 6, 2025
  If your Raymarine Marine Equipment connection is extremely slow or keeps dropping out, moving the display closer to the router can improve Wi-Fi performance. If possible, change the Wi-Fi Channel that your router is using and retry the connection, as interference from other devices may be the cause. Also, if possible, move your vessel to a location with less Wi-Fi traffic, as interference from devices on other vessels can impact the connection.
T
Travis HarrisSep 10, 2025
Why Raymarine Lighthouse Sport 3.10 Marine Equipment has network connection but no data?
- S
  Samuel KnoxSep 10, 2025
  If your Raymarine Marine Equipment has a network connection but no data, ensure that your display is connected to a network with an internet connection.

Raymarine Lighthouse Sport 3.10 Series Specifications

General

Category	Marine Equipment
Version	3.10 Series
Display Type	LCD
Chartplotter	Yes
User Interface	Lighthouse
Chart Support	Navionics, C-MAP
Compatibility	Raymarine Accessories
Screen Size	Varies by model (7", 9", 12", 16")
Operating System	LightHouse OS
Networking	Wi-Fi, Ethernet, NMEA 2000
Water Resistance	IPX6
Mounting Type	Flush mount, bracket mount