1. Select the waypoint or point of interest and select Goto from the context menu.
You can stop the Goto at any time by selecting Stop from the context menu, or by selecting
another
Goto.
The Chart app will begin active navigation.
2. Navigate your vessel to the destination point, using the Chart app as a guide.
3. Select
OK to accept the waypoint arrival alarm, which is triggered when you reach a specified
distance from the waypoint.
You can also perform a Goto from the
Go menu: Menu > Go .
Note:
In a network that contains 2 Element™ displays, with one display performing active navigation (i.e.:
performing a
Goto or a Follow) navigation options will not be available on the networked display.
Adjusting the waypoint arrival alarm
The waypoint arrival alarm is enabled by default. The waypoint arrival alarm creates a virtual circle,
of the specified radius, around the destination point. When your vessel reaches the virtual circle
the alarm is triggered.
From the homescreen:
1. Select
Settings.
2. Select the
Alarms tab.
3. Select the
Arrival radius: setting field.
4. Adjust the distance to the desired value.
5. Press the
Back button to return to the alarms menu.
Note:
The waypoint arrival alarm can be disabled or enabled using the
Waypoint arrival: toggle switch.
Restarting cross track error (XTE)
A cross track error (XTE) occurs when your actual route diverges from your original planned route.
Restarting XTE plots a new course directly from your current position to your destination, rather than
continuing to follow the original planned route.
1. Select
Restart XTE from the Navigation menu: Menu > Navigation > Restart XTE.
Chart app
85
To Next Page
Loading...
