www.raymarine.com/software
Note:
• It is recommended that you always backup your User data before performing a software update
.
• The “Check online” feature is only available on display variants that include built-in Wi-Fi that
have been configured with an active Internet connection.
• In order to perform a software update any connected radar scanner must be switched to standby.
In addition to updating your display’s software, your display can also be used to update the software
of devices connected to the same SeaTalkng ® backbone.
Identify display variant and software version
Refer to the Getting started menu: Homescreen > Settings > Getting started on your display to
identify product variant and current software version.
Identifying connected products
To display a list of products that are connected to the same SeaTalkng ® backbone follow the steps
below.
From the Homescreen:
1. Select
Settings.
2. Select the
This display tab.
3. Select Networked devices.
Product information for compatible products is displayed. The software version can be located
against
Application version:.
4. If required, use the
Up and Down buttons to scroll through the list of product information.
5. You can also save the list of product information to memory card by selecting
Save data.
Set up
35
To Next Page
Loading...
