Control Description
Gain
The gain control determines the signal strength at which target returns are
shown onscreen.
The gain control can be set to
Auto or Manual. In Auto you can apply an
offset of up to ± 50%.
A higher value produces more target returns and noise onscreen.
Intensity
The intensity control sets the lower limit for the color used for the strongest
target returns. All target returns above this value are displayed in the strongest
color
. Those with a weaker value are divided equally between the remaining
colors.
The intensity control can be set to
Auto or Manual. In Auto you can apply an
offset of up to ± 50%.
Surface Filter
The surface filter control determines the amount of noise displayed onscreen
by varying the gain throughout the water column.
A lower value decreases the depth at which the control is applied.
The control can be set to
Auto or Manual.
All to Auto
Sets all Sensitivity controls to
Auto with 0% offset, where applicable.
8.5 Configuring transducer settings
For systems with a transducer connected, as part of setting up your system for the first time it is
important that you correctly configure your transducer.
Transducer configuration settings are available from the Fishfinder app.
Fishfinder app
109
To Next Page
Loading...
