Chapter 2: Installation 5
Chapter 2: Installation
2.1 Introduction
This chapter explains how to install your RayData. If you are installing it
as a stand-alone unit, you will need to install the speed and depth
transducers and cables, and mount the RayData. If you are connecting
your RayData to a larger system, you should refer to the installation
instructions for the other units and for connection to the SeaTalk bus.
Note: Before attempting any installation, you should read the
Electromagnetic Compatibility (EMC) installation and service guidelines
provided in Section 2.2.
This chapter covers the following topics:
• Packing list
• Installing the depth and speed transducers
• Transducer cabling
• Mounting the RayData
• RayData connections
To Next Page
Loading...
