Chapter 5: Alarms 39
6. When you have set the value to the required number, press
ÚÚ
ÚÚ
Ú
and
ÙÙ
ÙÙ
Ù
together to exit to the Shallow Alarm page, with the new
value set.
7. If the alarm is off, press and hold
ÚÚ
ÚÚ
Ú
and
ÙÙ
ÙÙ
Ù
together for six seconds
to turn it on. The current alarm value is displayed.
If you do not wish to adjust the deep alarm limits, press DEPTH to return
to the Main Depth page.
Adjusting the Deep Alarm Limit
The minimum and maximum alarm depths you can select, and the
resolution of the alarms, depend on the units selected as follows:
Units Minimum Maximum Resolution
Depth Depth
Feet 10 400 Whole feet
Fathoms 2 50 Whole fathoms
Metres 3 120 Whole metres
The deep alarm limit must also be greater than the shallow alarm limit.
To adjust the deep depth alarm value:
1. Unless you are continuing after setting the shallow alarm, follow
steps 1 to 3 in the Shallow Alarm procedure (page 38).
2. Press the
ÙÙ
ÙÙ
Ù
key to display the Deep Alarm sub-page, showing the
current alarm limit, or ALARM OFF if the alarm is turned off. To
toggle the alarm between on and off, press and hold
ÚÚ
ÚÚ
Ú
and
ÙÙ
ÙÙ
Ù
together for six seconds.
3. Press
ÚÚ
ÚÚ
Ú
and
ÙÙ
ÙÙ
Ù
together. The Deep Alarm Adjust page is
displayed.
4. Adjust the value to the required setting, as described in step 5 in the
Shallow Alarm procedure (page 38).
5. Press
ÚÚ
ÚÚ
Ú
and
ÙÙ
ÙÙ
Ù
together to set the value and return to the Deep
Alarm page.
6. If the alarm is off, press and hold
ÚÚ
ÚÚ
Ú
and
ÙÙ
ÙÙ
Ù
together for six seconds
to turn it on. The current alarm value is displayed.
Press DEPTH to return to the Main Depth page, or
Ù Ù
Ù Ù
Ù
to move on to
the Anchor Alarm page.
To Next Page
Loading...
