Chapter 2: Installation 7
Check Before Going to Sea
• Always check the installation before going to sea to make sure that it
is not affected by radio transmissions, engine starting etc..
• In some installations, it may not be possible to prevent the equipment
from being affected by external influences. In general this will not
damage the equipment but can lead to it resetting, or momentarily
may result in faulty operation.
Servicing and Safety
•Raymarine equipment should be serviced only by authorised Raymarine
service engineers. They will ensure that service procedures and
replacement parts used will not affect performance. There are no
user serviceable parts in any Raymarine product.
• Some products generate high voltages, and so never handle the
cables/connectors when power is being supplied to the equipment.
•Always report any EMC related problem to your nearest Raymarine
dealer. We will use any such information to improve our quality
standards.
2.3 Packing List
Your RayData display should be supplied with the following:
• Power lead
• SeaTalk daisy-loom plug to plug cable
• NMEA cable assembly, consisting of one 39in (1 metre) cable plus
two female lug connectors
• Sun cover
• Thumb studs (4)
• Thumb screws (4)
• This handbook
• RayData Quick Reference Card
Some packing options also include depth and speed transducers, as
described in the following section.
In addition, an optional trunnion mount kit is available.
To Next Page
Loading...