RCA 20F514TD - Complete the Initial Setup; Set the Menu Language; Auto Channel Search; Tuning to a Channel

_12
Analog channel
entry
012-1_ _
Digital channel
entry
Tuning to a Channel
TheDIG•ANAbuttontogglesbetweenanaloganddigitalchannels.Analog
channelsdisplayinarectangleasyouenterthenumbers.Intheexampleto
theleft,youcanenter12or012togetthesamechannel.Toenteraone-digit
channel,suchaschannel8,justpress8.Afterenteringthechannel,pressOK.
TheCLEARbuttonontheremoteclearsallentries.
Digitalchannelscanhavebothprimarychannels(liketheanalogchannel
number)andsubchannels.Digitalchannelnumberscancontainuptosix
numbers.Numberstotheleftof the-(dash)arethemainchannelnumber;
numberstotherightarethesubchannelnumbersforstationsthatbroadcast
morethanonesignal.
Intheexample,press“1”,thenpress“2”(although012isshownintheexample,
pressing“0”isn’trequired).Nowpresstherightarrowbuttontomovetothe
subchannel.Press“1”andthen“OK.”Yourproducttunestochannel12-1.If 
channel12isbroadcastingsubchannelsignals,youwouldenternumbersthat
accesstheothersignals.(Example:12-1,12-2,12-3).If theselectiontimesout,
youmuststartover.
SETUP
Go back
Auto Channel Search
List & Labels
Closed Caption
Favorite Channel
Language Eng.
Format Normal
Auto Vol. Level Off
AUTO CHANNEL SEARCH
Go back
Source Type Cable
Start Search
Complete the Initial Setup
CustomizingitemsintheSetupmenuallowsyourproducttoperformcorrectly.Makesure
you’veconnectedtheTVtocableoranoff-airsignalbeforeyoucontinue.
SETUP
Go back
Auto Channel Search
List & Labels
Closed Caption
Favorite Channel
Language Eng.
Format Normal
Auto Vol. Level Off
Set the Menu Language
If Englishisyourpreferredlanguage,skipthisstepandgototheAutoChannel
Search.
Tochooseanotherlanguage,presstheTVMENUbuttonandthenselectOK.
ThisbringsuptheTV’sMainmenu.Pressthedownarrowbuttontohighlight
SetupandpressOK.FromtheSetupmenu,highlightLanguageandpressOK.
TochoosealanguageotherthanEnglish,presstherightarrowbuttononthe
remote.
Note: Make sure you’re in TV mode by pressing the TV•DVD button.
Auto Channel Search
Auto Channel SearchislocatedfromthispathMain Menu/Setup/Auto Channel
Search.Itallowsyourunittosearchforallchannelsavailablethroughyour
ANTENNA/CABLEINPUTjack.Thisissometimescalledautoprogramming.
1. FromtheAutoChannelSearchmenupresstherightarrowbuttontochoose
theSource Type(Cable or Antenna).ThedefaultisCable.
2. WiththeSignal Sourcechosen,highlightStart SearchandpressOK.Auto
ChannelSearchrunsasitndsalltheavailablechannels.Thechannelsearch
ndsbothanaloganddigitalchannels.(Whensearchingforcablechannels,
thisstepcantakesometime.Itcantakeapproximately30minutes).
3. Oncethesearchiscomplete,yourunittunestoachannel.Forinformation
oncustomizingyourchannelsormenuoptions,gotoChapter4.
Connections & Setup
14 Chapter 1