Red Jacket CoreDEF Series - Page 13

Introduction Kits And Accessories
9
4. Select the Control Box for each pump.
Existing applications may not require an Isotrol or a Control Box. In these applications ca-
pacitors can be purchased as listed in Table 6 on page 35.
5. Select optional accessories.
UMP (Capacitor or Heater)
Dispenser Hook
Voltage
DP75U1,
DP75U3-3
(17.5 F)
DP200U1
(40 F)
DP200U17
(CR123C526A)
DP200U4
(CR123C867A)
Single Phase
Control Box With
Capacitor
120V hook 880-045-5 410861-001 ------- --------
240V hook 410860-003 410860-001 ------- --------
Three Phase
Starter With
(3) Heaters
120V hook -------- -------- --------
410648-001
(3) 410649-010
240V hook -------- --------
410648-002
(3) 410649-003
410648-002
(3) 410649-010
Single Phase
Control Box and
Capacitor Kit
120V hook
880-041-5 &
410164-001
880-041-5 &
410164-003
-------- --------
240V hook
880-042-5 &
410164-001
880-042-5 &
410164-003
-------- --------
Item Part Number Description
NPT to BSP
Adapters - SST
(Stated adjust-
ment range of
column piping in
Figure 3 is
affected by use
of adapters)
410878-001
Male 1-1/4” NPT to Female 1-1/4” BSP
410879-001
Female 2” NPT to Male 2” BSP
Pressure Gauge 410880-001
1/4” NPT fitting- SST 316 components
NOTICE
10 50
20
60
30
40