To Next Page

To Previous Page

RED DSMC OPERATION GUIDE

955-0020_V5.1, REV-H | 120

the upgrade. The upgrade process can also be tracked on another display.

After the file transfer is completed, the REDMOTE displays the following: “Firmware Upgrade Successfully

Done”.

7. Click OK.

8. Click Disconnect to close the REDMOTE Upgrade Utility.

The REDMOTE reboots.

After the upgrade is complete, the REDMOTE displays “POWER UP” and then “SEARCHING”.

9. Select Cancel.

10. Go to Settings > Maintenance > System Status > Camera Info and verify the current REDMOTE firmware ver-

sion.

REDMOTE upgrade is complete and you can now attach it to the DSMC BRAIN.

NOTE: You may not need to pair the REDMOTE after upgrading REDMOTE firmware. However, you must pair

the REDMOTE after you upgrade camera firmware.

Questions and Answers:

Need help?

Do you have a question about the RED DSMC and is the answer not in the manual?

RED DSMC Specifications

General