RED DSMC OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC
955-0020_V5.1, REV-H | 93
LOWER CONTROLS
0From left to right, the screen displays the following: Playback/Record toggle, Histogram, Load Previous Clip,
Frame-by-Frame Reverse, Rewind, Play/Pause toggle, Frame-by-Frame Forward, Load Next Clip, Play Options,
Marker Options.
PLAYBACK/RECORD TOGGLE
Toggles between Record mode and Playback mode.
HISTOGRAM
Displays the clip histogram. The histogram changes based on any changes made to the Look settings. For more
information about Looks, go to “Looks” on page 102.
When using the touchscreen, touching the histogram displays the Tools menu.
PLAYBACK SPEED
Allows you to select x1, x2, x4, x8, or x16 playback speed.
IN/OUT POINT MARKERS
Allows you to set In and Out Points during clip playback. This allows you to play only a certain portion of the
clip. The In/Out Markers help when the clip is long and you want to focus on a particular segment. The In (red)
and Out (green) points display in the Playback Status Bar.
FRAME-BY-FRAME REVERSE/FORWARD
Allows you to move through the clip frame-by-frame, going either forward or in reverse.
PLAY/PAUSE TOGGLE
Allows you to play and pause the clip.
PLAY ONCE/LOOP TOGGLE
Allows you to choose to play the clip one time or to loop the clip in the player.
PLAYBACK DIRECTION TOGGLE
Allows you to play the clip forward or backwards.
ADDITIONAL CLIP/CAMERA INFORMATION
Will indicate if clip was recorded in HDRx, the current camera power status, and audio input signals.
POWER MENU
The power menu displays the current power status of all attached power sources as well as allows you to shut
down the camera.
NOTE: For more information about powering the DSMC, see the DSMC Power Operation Guide available at www.
red.com/downloads.
POWER IN
The power status is displayed for the BRAIN DC, DSMC SIDE HANDLE, Rear 1, Rear 2, Rear 3, and Rear 4.
The screen displays the voltage of the source or the percentage of the power left, as well as the time left, if
applicable.