RED DSMC OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC
955-0020_V5.1, REV-H | 133
DSMC NIKON MOUNT SUPPORTED LENSES
The DSMC Nikon Mount electronically supports the following lenses:
AF Nikkor 50mm f/1.8D
AF DX Fisheye-Nikkor 10.5mm f/2.8G ED
AF Fisheye-Nikkor 16mm f/2.8D (iris control only, no AF)
AF-S Nikkor 14-24mm f/2.8 G ED
AF-S Nikkor 17-35mm f/2.8D ED IF
AF-S Nikkor 17-55mm f/2.8G ED DX
AF-S Nikkor 24mm f/1.4 G ED
AF-S Nikkor 24-70mm f/2.8 G ED
AF-S Nikkor 35mm f/1.4 G
AF-S Nikkor 40mm f/2.8G DX
AF-S Nikkor 50mm f/1.4 G
AF-S Nikkor 70-200mm f/2.8 G II ED VR
AF-S Nikkor 85mm f/1.4 G
AF-S Nikkor 600mm f/4G ED VR N
AF-S Micro-Nikkor 60mm f/2.8 G ED
AF-S VR Micro-Nikkor 105mm f/2.8G IF-ED
Tamron SP 24-70mm f2.8 Di VC USD (iris control only, no AF)
Tokina AT-X 107 DX, 10-17mm f/3.5-4.5 Fisheye DX (iris control only, no AF)
Tokina AT-X 116 Pro DX, 11-16mm f/2.8 SD IF DX (iris control only, no AF)
Tokina AT-X 116 Pro DX-II, 11-16mm f/2.8 SD IF DX (iris control only, no AF)
DSMC LEICA-M MOUNT LENSES
The RED DSMC LEICA-M Mount is compatible with all Leica M-series lenses with focal lengths of 50mm and
greater EXCEPT the 50mm f2.0 Dual-Range Summicron. The 50mm Dual-Range Summicron has a protruding
lug on the exterior of the lens body for mounting a supplementary finder, and this lug interferes with the DSMC
LEICA-M Mount’s lock ring.
Most Leica lenses with focal lengths of less than 50mm will encounter mechanical interference between the rear
lens cell and the camera’s front panel.
NOTE: Attempting to mount Leica lenses of focal lengths of less than 50mm could result in damage to the lens
and/or the camera.
A new OLPF frame (included) is required to use the Leica-M mount.
Replacement OLPF frame is compatible with all DSMC lens mounts.
OLPF frame upgrade may be performed by customer or RED, free of charge.
To Next Page
Loading...
Need help?
General
