RED DSMC User Manual

RED DSMC OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC
955-0020_V5.1, REV-H | 19
INSTALL DSMC SIDE HANDLE
WARNING: The DSMC SIDE HANDLE is NOT HOT SWAPPABLE, meaning you cannot remove or install the DSMC
SIDE HANDLE while the camera is powered on. Before installing or removing the DSMC SIDE HANDLE, you
MUST power down the camera. Failure to do so may result in damage to the DSMC SIDE HANDLE or DSMC
that will not be covered under warranty.
REQUIRED TOOL: T10 Torx
®
driver
1. Power down the camera.
2. Use a T10 Torx driver to remove the single screw located at the bottom of the BRAIN side plate (if installed).
3. Rotate the BRAIN side plate upwards to disengage the lip at the top of the side plate from the camera
BRAIN, and remove the BRAIN side plate.
4. Insert the lip at the top of the DSMC SIDE HANDLE into the area where the lip from the BRAIN side plate
was installed.
5. Press the DSMC SIDE HANDLE down flush along side of camera BRAIN.
6. Rotate the thumbscrew upward while applying steady pressure until tight.
REMOVE DSMC SIDE HANDLE
WARNING: The DSMC SIDE HANDLE is NOT HOT SWAPPABLE, meaning you cannot remove or install the DSMC
SIDE HANDLE while the camera is powered on. Before installing or removing the DSMC SIDE HANDLE, you
MUST power down the camera. Failure to do so may result in damage to the DSMC SIDE HANDLE or DSMC
that will not be covered under warranty.
1. Power down the camera.
2. Rotate the thumbscrew downward until the DSMC SIDE HANDLE detaches from the camera body.
3. Pull the bottom of the DSMC SIDE HANDLE away from the BRAIN to disengage the lip at the top of the
DSMC SIDE HANDLE away from the camera BRAIN.
4. Remove the DSMC SIDE HANDLE from the camera.

RED DSMC Specifications

General

Brand	RED
Model	DSMC
Category	Digital Camera
Language	English