RED DSMC OPERATION GUIDE: WEAPON
COPYRIGHT © 2015 RED.COM, INC 955-0116_V6.1, REV-H | 141
11. Turn on the BRAIN.
The camera may take 30 seconds or longer to upgrade all the attached modules. During this time the PWR
and REC LEDs flash green and nothing displays on the external monitors.
12. If this is your first time upgrading firmware, a pop-up menu opens with the Software License Agreement
(SLA). Select Agree.
NOTE: If you do not agree to the SLA, the camera cannot be used. The SLA continues to display until it is
accepted.
13. Go to Menu > Settings > Maintenance > System Status > Camera Info and verify that the firmware version listed
matches the firmware version that you downloaded.
14. To restore user-generated preset files to your camera, follow the instructions below:
A. Turn on the BRAIN and insert the SSD with the saved preset files into the camera.
B. Go to Menu > Presets and copy user-generated Camera Preset and Look files from the SSD to the cam-
era.
C. Go to Menu > Settings > Display > Monitor Control > Overlays and copy user-generated Overlay files from
the SSD to the camera.
15. After offloading firmware upgrade files and preset files from an SSD, reformat the SSD before recording.
To Next Page
Loading...
