RED WEAPON 6K - Configure Your WEAPON

RED DSMC OPERATION GUIDE: WEAPON
COPYRIGHT © 2015 RED.COM, INC 955-0116_V6.1, REV-H | 33
TURN ON THE BRAIN
1. Attach a power source to the BRAIN.
The Power Status LED illuminates red, indicating that an appropriate power source is connected.
2. Press and release the PWR/REC button on the right side of the BRAIN.
The Power Status LED turns off, and within five (5) seconds illuminates yellow as the BRAIN turns on.
The Power Status LED then illuminates green to confirm that the BRAIN is turned on and ready to use.
NOTE: The Power Status LED flashes red when there is less than five (5) minutes of operating time remaining.
TURN OFF THE BRAIN
Use one of the following methods to turn off the BRAIN:
 Go to Menu > Power and select Shutdown.
 Press and hold PWR/REC until the Shutting Down... notification shows on the display.
NOTE: The DSMC turns off automatically if the supply voltage drops to 11.5 V.
CONFIGURE YOUR WEAPON
This section describes common options for configuring your WEAPON system.
INSTALL THE DSMC
2
SIDEKICK
This section applies to the following items:
 DSMC
2
Sidekick (Forged CF)
 DSMC
2
Sidekick (Woven CF)
 DSMC
2
Sidekick (Magnesium)
NOTE: Each DSMC
2
Sidekick is compatible with both WEAPON (Carbon Fiber) and WEAPON (Magnesium).
WARNING: Before installing or removing the DSMC
2
Sidekick, you MUST turn off the BRAIN.
REQUIRED TOOL: T10 TORX
®
driver
1. Turn off the BRAIN.
2. Use a T10 TORX driver to remove the four (4) screws on the BRAIN side plate (if the side plate is installed).
3. Remove the BRAIN side plate (if the side plate is installed).
4. Place the DSMC
2
Sidekick in the slot where the lip of the BRAIN side plate was installed.
5. Press the DSMC
2
Sidekick down flush along the side of BRAIN.
6. Tighten the four (4) captive screws in a cross pattern (“X” pattern) using a T10 TORX driver. DO NOT FULLY
TIGHTEN.
7. Fully tighten the four (4) screws in a cross pattern (“X” pattern) using a T10 TORX driver.
WARNING: DO NOT OVERTIGHTEN.