COPYRIGHT © 2015 RED.COM, INC
RED DSMC OPERATION GUIDE: WEAPON
955-0116_V6.1, REV-H | 170
POWER PORTS
DC IN (POWER INPUT)
The DSMC
2
Base Expander features a headphone jack.
The 6-pin 1B LEMO connector accepts DC input power from 11.5 V DC to 17 V DC. A built-in power conditioner
protects against reverse-polarity connections, electrostatic discharge (ESD), undervoltage, overvoltage, and
overcurrent.
WARNING: Both pairs of +VBATT and GROUND pins must be wired. Using a third-party power cable that wires
only one (1) pair of +VBATT and GROUND pins may damage the power supply or the DSMC
®
. Damage to the
power supply or other components of the DSMC system caused by using an inappropriate power cable is not
covered under warranty.
3
4
5
6
1
2
6-PIN 1B DC INPUT CONNECTOR
PIN SIGNAL DESCRIPTION
1 +VBATT Power input, +11.5 to +17 V DC
2 +VBATT Power input, +11.5 to +17 V DC
3 SCL-BATT Serial battery bus clock
4 GROUND Power return (camera ground)
5 GROUND Power return (camera ground)
6 SDA-BATT Serial battery bus data
NOTE: Mating connector is FGJ.1B.306.CWLD72Z.
COMPATIBLE CABLES
790-0138: 2B-to-1B LEMO Power Adaptor Cable
790-0164: XLR Power Cable (10')
790-0165: XLR Power Cable (30")
Front Face of the DC In Power Input
Connector (Looking at the DSMC)
To Next Page
Loading...
