RED WEAPON 6K - Page 34

COPYRIGHT © 2015 RED.COM, INC
RED DSMC OPERATION GUIDE: WEAPON
955-0116_V6.1, REV-H | 34
REMOVE THE DSMC
2
SIDEKICK
This section applies to the following items:
 DSMC
2
Sidekick (Forged CF)
 DSMC
2
Sidekick (Woven CF)
 DSMC
2
Sidekick (Magnesium)
NOTE: Each DSMC
2
Sidekick is compatible with both WEAPON (Carbon Fiber) and WEAPON (Magnesium).
WARNING: Before installing or removing the DSMC
2
Sidekick, you MUST turn off the BRAIN.
REQUIRED TOOL: T10 TORX driver
1. Turn off the BRAIN.
2. Use a T10 TORX driver to loosen the four (4) captive screws attaching the DSMC
2
Sidekick to the BRAIN.
3. Remove the DSMC
2
Sidekick from the BRAIN.
INSTALL A DSMC
2
EXPANDER
This section applies to the following items:
 DSMC
2
Base Expander
 DSMC
2
REDVOLT Expander
 DSMC
2
Jetpack Expander
WARNING: Before installing or removing a DSMC
2
expander, you MUST turn off the BRAIN.
REQUIRED TOOL: T20 TORX driver
1. Turn off the BRAIN.
2. Position the expander on the rear of the BRAIN, aligning the connector on the front of the expander with
the connector on the rear of the BRAIN.
3. Apply pressure and tighten the four (4) captive screws in a cross pattern (“X” pattern) approximately two (2)
turns each using a T20 TORX driver. DO NOT FULLY TIGHTEN.
4. Fully tighten the four (4) screws in a cross pattern (“X” pattern) using a T20 TORX driver.
WARNING: DO NOT OVERTIGHTEN.
REMOVE A DSMC
2
EXPANDER
This section applies to the following items:
 DSMC
2
Base Expander
 DSMC
2
REDVOLT Expander
 DSMC
2
Jetpack Expander
WARNING: Before installing or removing a DSMC
2
expander, you MUST turn off the BRAIN.
REQUIRED TOOL: T20 TORX driver
1. Turn off the BRAIN.
2. Loosen the four (4) captive screws in a cross pattern (“X” pattern) using a T20 TORX driver.
3. Remove the expander from the BRAIN.