MOSAIC SAFETY DESIGNER SOFTWARE
The "MOSAIC SAFETY DESIGNER" application software can be used to configure a logic
diagram of the connections between the MOSAIC (Master + expansions) and the
components of the system being developed.
The MOSAIC and its SLAVE units will thus monitor and control the connected safety
components.
The MSD uses a versatile graphic interface to establish the connections between the various
components, as described below:
Installing the software
PC HARDWARE requirements
• RAM: > 2 GB
• Hard disk: > 500MB of free space
• USB connector: 2.0 or higher
• Internet connection for program download
PC SOFTWARE requirements
• Windows 7 with Service Pack 1 installed (or higher OS).
• Microsoft Framework 4.8 (or higher).
Installation of MSD software
• Download the last available version from the Download section of the ReeR
website: https://www.reersafety.com/it/en/download/configuration-software.
• Run the “SetupDesigner.exe” file.
• Wait for the auto-run installer to request the SW setup program.
➔
When the installation procedure is complete a window is displayed asking you to close the setup
program.
To Next Page
Loading...
